Part created in solid works also the blue marker represents the origin of the part that was created.
Feature Manager Design Tree
Part Volume : 56.37 cubic inches
Part Surface Area : 150.11 square inches
Location of Center of Mass : X = 0.97 Y = -4.12 Z = -2.26
2D Drawing of the part :
The drawing of this robot uses 2 wheel motor design with a 3rd wheel that is just a dummy wheel. The 2 bumper switches will be used in the front of the robot so when it hits the wall it will back up. The 3 senors will be placed one in the front and one on each of there sides. The breadboard, battery, Arduino and motor shield will be placed on top of the robot were it can be easy placed and wired.
Holder for the sensors
(3 of them would be made 1 for the front and 1 on each side of the robot car)
No comments:
Post a Comment